Louisville Knob & Tube is a knob and tube rewiring service for Louisville and Jefferson County, and Old Louisville is one of the areas where that work concentrates. Here is what rewiring here usually involves.
Old Louisville is where we do our longest jobs. The brick and stone houses around St. James Court and Central Park went up in the 1880s and 1890s, and many were electrified early, which means first-generation knob and tube snaking through three floors, a carriage house, and sometimes a butler stair nobody has opened in decades. A house on Millionaires Row can carry over a mile of original conductor.
The good news is that these houses were built with generous basements and tall attics, and that helps us. We fish new circuits through closet chases and floor cavities, and we plan the run before we cut anything. Plaster medallions, pocket doors, and original trim stay where they are. When a wall does have to open, we cut small, square, and where the patch can hide.
Many Old Louisville houses were split into apartments in the mid 1900s and are being converted back. Those conversions layered new wiring on top of old, so a live knob and tube circuit often hides behind a 1970s panel that looks modern from the front. Our assessment traces every circuit to its end before we quote.
What rewiring a Victorian here involves
Old Louisville sits in a local preservation district, so exterior changes need review, but interior rewiring does not. Your permit is a standard Louisville Metro electrical permit, and we file it. Inspectors here know these houses well and check that abandoned knob and tube is actually dead, not just capped.
Streets and courts we work
We cover all of Old Louisville, including around St. James Court, Belgravia Court, Central Park, Third Street and Millionaires Row. Nearby, we also rewire The Highlands and Crescent Hill, and the full published price table lives on the cost guide.
Old Louisville rewiring questions
My Old Louisville house is three stories. Do you have to open the plaster walls?
Usually not much. Tall basements and attics let us feed most circuits vertically through closets and chases. On a typical three-story we open a handful of small plaster cuts, mostly at switch drops, and we patch them square so your plasterer or ours can finish flush.
How much does it cost to rewire a big Victorian in Old Louisville?
Large three-story houses here run $24,000 to $38,000 for a full rewire with a 200 amp panel. Smaller two-story houses in the district land between $14,000 and $25,000. The walkthrough assessment is $250 to $450 and gets credited to the job.
The house was converted to apartments. Does that change the rewiring?
It changes the tracing. Conversions added subpanels and spliced old circuits in ways no drawing records. We trace every circuit to its end during the assessment, so the quote covers what is actually in the walls, and you do not get change orders mid job.
Will rewiring hurt the historic character of the house?
No. Interior electrical work is not restricted by the preservation district, and we work to keep original plaster, trim, and hardware untouched. Devices go back in the same boxes where code allows, and we can match period-style plates.
Get a quote for your Old Louisville house
Start with the address. The circuit trace maps what is live, and the quote is written and itemized per circuit.