Louisville Knob & Tube is a knob and tube rewiring service for Louisville and Jefferson County, and Portland is one of the areas where that work concentrates. Here is what rewiring here usually involves.
Portland predates almost everything else in Louisville, and much of its housing has had fewer renovation cycles than the neighborhoods east of downtown. That means we find more fully original systems here: knob and tube from the service entrance to the last ceiling box, sometimes never touched since installation. For a rehabber that is actually the clean scenario, one system, one plan, everything replaced at once.
Rehab activity along Portland Avenue and Northwestern Parkway has picked up, and wiring is where those budgets go right or wrong. We work with several Portland rehabbers on a rough-in plus finish schedule that fits between demo and drywall, and we quote from plans before purchase when asked. If you are pricing a shotgun or a storefront house here, call before you close on it.
Service upgrades and the utility side
Portland houses often kept their original exterior service masts and 60 amp feeds. LG&E requires the utility side coordinated when the service upgrades to 200 amps, and we handle that scheduling as part of the panel work, so the power company visit lands inside the same job window.
Portland streets we cover
We cover all of Portland, including around Portland Avenue, Northwestern Parkway, Montgomery Street and Portland Museum. Nearby, we also rewire Butchertown and Beechmont, and the full published price table lives on the cost guide.
Portland rewiring questions
I am buying a Portland house to rehab. Can you quote from a walkthrough before I close?
Yes. The $250 to $450 assessment works pre-purchase, and rehabbers use it to set the electrical line in their budget before making an offer. If you proceed with the job, the fee credits against it.
The house has been vacant for years. Does that change the rewire?
Vacant houses are usually simpler, since we can open runs without living around furniture and drywall schedules. If the service was disconnected, we coordinate the LG&E reconnect with the new panel so the house comes back on at 200 amps.
What does a full rewire cost in Portland?
Shotguns and small cottages run $8,500 to $13,000. Larger two-story houses run $14,000 to $22,000 here, often below the metro top end because so many are open to the studs during rehab, and open walls cut labor.
Do you do the rough-in now and finish after drywall?
Yes, that is the normal rehab sequence. Rough-in, inspection, drywall, then trim-out and final inspection. We schedule both inspections with Louisville Metro so your other trades are not waiting.
Pricing a Portland rehab? Start with the wiring
Start with the address. The circuit trace maps what is live, and the quote is written and itemized per circuit.